Home Theater Installation and Consumer Electronics

Kicker 42PXA2001 200W x 1 Moto/Marine Amplifier
Skip to content
|

Kicker 42PXA2001 200W x 1 Moto/Marine Amplifier

Sold out
Original price $ 159.95 - Original price $ 159.95
Original price
$ 159.95
$ 159.95 - $ 159.95
Current price $ 159.95
SKU KIC42PXA2001.FBA

Kicker 42PXA2001 Compact Mono Subwoofer Amplifier — 200 watts RMS x 1 at 1/2 ohm

 

 

Yes, ladies and gents, Kicker's 42PXA200.1 amplifier is a 200-watt powerhouse that's not much bigger than a deck of cards. That's right, it's astonishingly small for an amp, which means you can get creative and stash it in nearly any nook or cranny in your car. And at that size, we bet you could find a place for it on your ATV or boat too. Kicker designed this amp for you open-air easy riders, with a weather-resistant enclosure, no-rust mounting hardware, a single Molex plug for all wiring, noise-killing circuitry, and plenty of power to combat wind and road noise.

 

 

Product Highlights:

 

  • - mono subwoofer amplifier (selectable to work in any vehicle with a 12-volt charging system)
  • - 200 watts RMS x 1 at 1/2 ohm
  • - 100 watts RMS x 1 at 1 ohm
  • - 50 watts RMS x 1 at 2 ohm
  • - frequency response: 25-120 Hz
  • - switchable low-pass filter (60, 80, 100 or 120 Hz at 24 dB/octave)
  • - KickEQ™ Bass Boost (selectable 0dB or +6dB, centered at 40Hz)
  • - fixed subsonic filter (25 Hz, 24 dB/octave)
  • - preamp and speaker-level inputs as well as two auto turn-on modes (DC offset or 12-volt trigger)
  • - 14-gauge power and ground leads recommended — wiring and hardware not included with amplifier
  • - fuse rating: 15A x 1
  • - 4-3/4"W x 1-5/8"H x 3-7/16"D

 

 

Feel The Bass

 

The amp delivers up to 200 watts RMS to a low-impedance load, so you'll have all the power you need to make the right sub thump. Kicker also gives you a subsonic filter and selectable KickEQ™ Bass Boost to dial in the low range to your liking.

 

  • - Mono amplifier
  • - 12" Input/Output harness
  • - In-line fuse holder on 14-gauge wire
  • - 15A ATO fuse (installed)
  • - Four 1" Self-tapping screws
  • - Two 14-16 Gauge crimp-on ring terminals
  • - Two 11-7/8" plastic wire ties
  • - Owner's Manual (Eng/Span/Ger/Fren)